Table of Contents
Installing widebody fender flares on your Dodge can enhance its appearance and protect the wheel wells. However, improper installation can lead to damage or misalignment. This guide provides step-by-step instructions to help you install your fender flares safely and effectively.
Preparation Before Installation
Before starting, gather all necessary tools and parts. You will need screwdrivers, a drill, mounting hardware, and the fender flares. Ensure your Dodge is parked on a flat surface and the vehicle is turned off with the parking brake engaged.
Step-by-Step Installation Process
1. Clean the Fender Area
Thoroughly wash and dry the wheel wells to remove dirt and debris. This ensures proper adhesion and attachment of the fender flares.
2. Test Fit the Flares
Hold the fender flares against the wheel arches to check fitment. Make any necessary adjustments before drilling or fastening.
3. Mark Drilling Points
Use a marker to mark where the mounting holes will go. Be careful to align the flares properly and avoid damaging paint or wiring.
4. Drill Pilot Holes
Carefully drill small pilot holes at the marked points. Use a drill bit appropriate for your vehicle’s body material to prevent cracking.
5. Attach the Flares
Secure the fender flares using the provided hardware. Tighten screws gradually and evenly to avoid warping or cracking the flare or vehicle body.
Final Tips for Safe Installation
- Work in a well-lit, clean area to prevent accidents.
- Use masking tape to protect the paint around drilling sites.
- Do not overtighten screws, as this can cause damage.
- Double-check alignment before fully tightening all fasteners.
- Follow the manufacturer’s instructions specific to your fender flare model.
By following these steps, you can safely install widebody fender flares on your Dodge without risking damage. Proper installation not only improves your vehicle’s look but also ensures long-lasting protection and performance.